FS19 Cozad 110t v1.0.0.1
Change Log v1.0.0.1:
Corrected 5th axle group not recentering when fold/unfold is pressed
This trailer can haul up to 110 short tons (220,000 lbs, 99,790kg)
Usable deck length is 28’, but can be extended up to an additional 28’. It weighs 114,100 lbs (51,755 kg)
Features:
Jeep:
Independent color selection for inner and out frame
Configurable position for bridge attachment point.
All hoses modeled either through dynamic hoses or 3d model
Front Bridge:
Independent color selection for inner and outer frame
Manually steerable wheel group (considered 2nd group)
Auto recenter by pressing fold/unfold key/button
All hoses modeled either through dynamic hoses or 3d model
Front Gooseneck:
Independent color selection for inner and outer frame
Hydraulic tower movable by right mouse axis up/down
Configurable flood lights (forward facing, rear facing, or both)
All hoses modeled either through dynamic hoses or 3d model
Main Trailer:
Independent color selection for inner and outer frame
Hydraulic tower movable by right mouse button up/down
Configurable flood lights (forward facing, rear facing, or both)
Auto steer axle groups 3 and 5
Manual steering of axle groups 3 and 5
Auto steering recenter using fold/unfold key/button
All hoses modeled either through dynamic hoses or 3d model
Configurable deck extensions (7 ft, 14 ft, 21 ft, and 28 ft)
Configurable outriggers for all deck lengths
Transport Mode (works best with deck extensions):
1. remove gooseneck from main trailer
2. Drive jeep and bridge onto main trailer
3. Disconnect from Jeep
4. Go to main trailers steering platform and enter trailer
5. use middle mouse button (AXIS_FRONTLOADER_TOOL5) to flip king pin below deck front and to lower collision which will allow you to attach a truck underneath.
6. Attach main trailer to truck
7. raise collision
Do steps in reverse to make trailer ready for loads.
